Monday – Friday: 7:00am to 4:30pm PST      
Call Toll Free 1.800.364.0287
41610 Date St #104 Murrieta, CA 92562

APPLICATION VIDEOS

(English)
(Spanish)
Elastomeric Coated Roofs

Before installing the product, ensure that the assembly will support the weight load of the sloping material; the product weights approximately 2.5  pounds per square foot when applied at ¼” thick. The low sloped areas will need to be identified and a screed board will need to be set so as to determine the amount of sloping material needed to achieve a positive pitch towards drains or scuppers. Thoroughly inspect the areas to be coated to ensure that the contiguous areas will not limit your sloping ability. The existing roofing application must be thoroughly cleaned and free from contaminants.

Prime

The RoofSlope product is self priming and can be installed over existing surface moisture; simply ensure that all ponding water is broomed off the surface.

Application

Once the areas have been properly prepared, apply the RoofSlope Product by mixing one 50 pound bag of RoofSlope with approximately 1 ¼ gallons of water. The mix will be extremely wet, almost to the consistency of self leveling. Apply the RoofSlope Mix by using a screed board and a trowel to achieve the appropriate slope, and broadcast the desired 16 grit silica sand or granules into the wet mixture until refusal.

Cure

Once the material cures, the installation is complete and the low sloped areas of the roof will tie into the aesthetics of the surrounding roofing composition and the ponding water should be corrected.

Downloadable Documents
MasterWorks Program Open the Door to a World of Opportunities with Exclusive MasterWorks Growth-Driving Programs